We are attempting to set up a NCD X-terminal Xncd19 to boot up with
NCDware v3.0.1 from an HP-UX 10.20 host. The X-terminal gets its
boot image fine, but it then is unable to read its config file(s).
Two lines of error messages are repeatedly displayed afterward,
e.g.:
CONFIGD-E: Unable to read config file /usr/lib/X11/ncd/configs/ncd_std
CONFIGD-E: Unable to read config file /usr/lib/X11/ncd/configs/########
...
...
where "########" is the hexadecimal equivalent of its IP address.
We've set this up before on SunOS, successfully. Any clues/ideas as
to why it's not working fully on HP-UX would be much appreciated via e-
mailto:espiritu@cgi.com
Thanks in advance.
--
Rex Espiritu
espiritu@cgi.com
--------------<< "ncd-users@ncd.com" FOOTER MESSAGE >>-------------------
To Unsubscribe: Email ncd-majordomo@ncd.com with "unsubscribe ncd-users".
Anonymous FTP Site: ftp.ncd.com - unsupported host binaries, tech notes, etc.
WWW Site: http://www.ncd.com/ - product,service & company info
Archive of List: Use "index" and "get" commands to ncd-majordomo@ncd.com
NCD reserves the right to restrict access to this list.